Metrolink EMD F125 Simulation Patch

  • by ml302
  • 2 upvotes
  • Downloaded 279 times

This mod simply replaces the simulation curve relating to throttle notches versus tractive effort on the SBD version of the F125 with the one from the SBD MP36. This allows for much less effort to be produced in the lower throttle notches, providing better control in low speed and gradient situations. This results in better handling overall but specifically over the low speed gradient sections found on the Antelope Valley, where you no longer need to cycle between notch 1 and idle to maintain speed. The loco still behaves the same as the default F125 otherwise, so it is still rather slow to load from idle but is also still quite quick in the higher notches when it gets going.

In the future I may look at completely redoing some of these simulation curves to provide a better simulation, but as is this mod does the job.

This mod only applies to the SBD version of the F125, and it also removes the Antelope Valley version from subbing into services, making this the default and only version across most timetables.

Requirements

Train Sim World® 5: Antelope Valley Line: Los Angeles - Lancaster Route Add-On on Steam

Not required but will remove substitution from the AVL F125 in favor of using the patched SBD version.

Tags: f125 metrolink

Files

!!!!TS2Prototype-WindowsNoEditor-F125Simulation.pak 5 KB · Added 24 days ago · Downloaded 279×

Comments

Nobody has commented yet.

Add a comment

If you wish to leave a comment, please log in .

About this mod

Created
24 days ago
Updated
24 days ago
Game
Train Sim World
Type of content
Patch
Train Sim World compatibility
Train Sim World 5
Train Sim World Content
San Bernardino Line: Los Angeles - San Bernardino